Comparison of wireless performance between H3C B5 and Tengda mw6 1A

Take the 1A version of Tengda mw6 for a simple test, and compare with the h3cb5 with the same chip scheme to see if there is a gap.

Put the two in the WiFi position in the figure below, and the computer will test the wireless signal strength in four positions a, B, C and D respectively.

Tengda mw6 does not support the separation of 2.4G and 5g, but the signal strength analysis software can see two WiFi signals, which is 2.4G and which is 5g according to the wireless channel.

If the signal strength is as follows: (strong above, weak below)

2.4G of mw6 and 5g of h3cb5 at point a;

At point B, 2.4G is stronger than mw6, and 5g signal h3cb5 is stronger than Tengda mw6;

At point C, 2.4G is better than mw6, 5g is better than B5;

At point d downstairs, 2.4G and 5g are about the same.

In general, the 2.4G of mw6 is better than that of h3cb5.

Then I test the wireless network speed. This test uses a new method. I installed the Speedtest service on a computer (win10). When testing the speed, it's simple. What DMZ doesn't need to be set at all? As long as the mobile phone or computer input the IP address with a browser, it can measure the speed, and it can also set some parameters, such as the speed time (seconds). I always think Speedtest App speed measurement time is short, so I customized 30 seconds. The following picture:

However, there is a serious problem that hasn't been solved, that is, I can't measure the speed of the connection, otherwise I will make mistakes, and I will wait about a minute before testing. The errors are as follows:

Do you know how to solve this problem, or do you need to use other operating systems to install Speedtest?

The way to test is that a computer (Speedtest server) is connected to the WAN port of the router, and the speed is measured with the Xiaomi 4C of the mobile phone. Because it takes one minute to test the second time each time, I shorten the times from the previous six times to four times, and finally take the average value. In this way, I have no more efficiency than ixchariot tool. (I only tested 5g, mw6 can't be separated from 2.4G and 5g, just afraid of trouble). It is also the four positions when testing the signal.

All results are as follows:

Comparison of 5g downlink speed average:

Comparison of 5g upstream speed average:

There is a big difference in the uplink speed.